Interestingly enough, LED grow lights offer a few assembly and setup options. Most LEDs don’t require you to put anything together, unlike HIDs that require you to assemble a reflector, ballast, and bulb. For the most part, they’re straightforward:
1.Install the light hangers onto the LED light/panel.
2.Hang the lights above your plants.
3.Plug in your lights to their power outlets and turn on the lights.
Now, there are lights like those from Horticulture Lighting Group that require some assembly. Though it’s not difficult, you’ll receive a mounting board, a driver, and a number of LED panels to install. In these cases, here’s what you’d do:
1.Lay out the mounting board and lay out each panel where they belong on the board.
2.Fasten the panels to the mounting board. Some use screws, while others may use an adhesive, so adhere the diodes to the board as instructed.
3.Install the driver (a ballast for LEDs) where instructed, usually on the back of the mounting board. like the STG-600W-F.There also some driver install inside like STG-720-F.
4.Wire the diode panels into the driver.
5.Install your mounting hardware and hang your LED grow light over your plants, then plug your light in and turn it on.
There are also certain lower wattage LEDs bulbs that you can install into flood lights, too. Those are as simple as screwing the LED bulb into the flood lamp, plugging in the lamp, and turning it on.
